#FACTORIO DOWNLOAD 0.17 GOG MOD#
#FACTORIO DOWNLOAD 0.17 GOG UPDATE#

The key difference between the designs is this: the 2xN uses 42 turbines on one fluid group, the 2x2 has 2 turbines per fluid group, the 2x2 shared steam uses 21 turbines in a fluid group, and the reactor conducting once again uses 2 turbines per fluid group.Ī further test case is that of oil processing. It isn't completely viable to describe each nuclear design here, but if you download the maps you can check them out. It therefore serves as a good benchmark amount of power generation. This value is roughly the amount of power consumed by /u/schaev's 10K SPM rotationally symmetric base. We will test a 2xN nuclear setup, a 2x2 reactor setup, another 2x2 reactor setup (shared steam), and a reactor setup where nuclear reactors are used to transfer heat instead of heat pipes.įor each reactor, we will scale the power demand to approximately 60GW. This test will focus on 4 specific designs. There are a wide variety of nuclear designs, and it's simply not viable to test them all. It also heavily uses the fluid system so any performance delta would be interesting to see. As far as I know, no fundamental changes occurred to nuclear power mechanics. Thus, we expect there to be little to no performance difference.Ī further area of much interest is nuclear. There is very little to this test as the cars are fully stationary. These cars can either be intersecting with each other or spread out. The next case to test is one where we have ~90k cars. A grid arrangement could yield a different performance characteristic, but that shall be left to a future test.įor this case, we will test with the pipes completely empty, as well as a situation where each pipe contains exactly 50 water. For the sake of this test we will arrange our pipes in a line. As 512*256 = 131072, we can easily confirm the same quantity of pipes exist here. The other permutation to this test case is to connect 512 pipes at a time into 256 pipe groups. If we assume that each thread has a little bit of overhead, we would expect this to perform worse. According to information mentioned by the developers, this should spawn just as many threads as pipes. This achieves 131072 pipes in 131072 pipe groups.

First, there will be the case where every single pipe is not connected to any other. There will be two configurations/layouts of pipe. We will produce two primary scenarios, each consisting of 131072 pipes per map. The first test case is to test pipes independently of any other factor. We will produce several test cases that fall into one of these two categories. In this initial round of tests, we aim to focus on the first two categories. 1k SPM in 0.16 looks very different than 1k SPM in 0.17, yet the same amount of apparent work is being performed. Tests in this category would vary greatly on their comparability. Another case would be maintaining the exact same layout but profiting off the greater idle time on the furnaces. Since the craft time for plates changed from 3.5s to 3.2s, you might be able to design something requiring fewer furnaces. For example, this could be a bot based red science build. The final category is where you don't attempt to make the test cases exactly similar. This means any test containing belts should be taken with a degree of salt. The distance between items on a belt is apparently hard coded deep within the game's engine, and the value is not modifiable by mods. One such example is the change in item spacing on belts. The third category is for changes which cannot be reverted with mods.

#FACTORIO DOWNLOAD 0.17 GOG MOD#

Since we can mod this value back to the 0.16 value, it is a reasonably comparable test. Such an example is where the crafting speed of chemical plants was changed from 1.25 to 1. The next test group is where numbers accessible via modding have changed. The mass of train rolling stock, and the top speed/acceleration remains the same. In both relevant versions of Factorio, none of the mechanics governing train transport have fundamentally changed. Tests which exploit the changes brought by new recipes or mechanics.Īn example test of our first category is a train travelling between stations A and B.Tests which cannot be modded to achieve a straight apples to apples comparison.Tests which can be made comparable with modding.It would be best to categorize potential tests into one of several categories. Since so many things changed, not everything can be reasonably compared between 0.16 and 0.17. Now, each pipe group has its fluid processed by an independent thread, potentially lifting that work off the main thread. One of the biggest changes was the handling of fluid.

#FACTORIO DOWNLOAD 0.17 GOG UPDATE#

The Factorio 0.17 update brought with it numerous changes that could affect performance. The overall performance generally improved, however there are still many cases to test, as well as a few situations where performance regressed. Test-000017 : A performance comparison of 0.16 and 0.17.

Factorio download 0.17 gog